Ground Penetrating Radar Systems Inc.

Disney Springs – GPRS Project in Orlando, FL

A contractor was planning to make several cuts in a slab on grade in the new additions at Disney Springs in Orlando, FL. The contractor was planning to install new electrical equipment and plumbing and had to make 5-6 trenches through the slab on grade concrete slab. The area they needed to have scan was roughly 20’x30’ in size. They contacted Ground Penetrating Radar Systems knowing that this was the exact type of work they specialize in.

Once on site GPRS used their 1600MHz antenna, specifically designed to provide high resolution concrete images of the precise location of any rebar, post tension cables and electrical conduits. Ground penetrating radar is an effective and efficient tool for accomplishing these goals and GPRS had the area mapped on the surface of the concrete in less than 2 hours. Once the marking was complete the ground penetrating radar specialist took time to explain the results so the contact would know exactly where to cut. This ensured that the building did not face any structural damage and, more importantly, that the contractor was safe during the cutting process. All parties were pleased with the results and the trenches were cut without incident.

If you would like to receive a proposal for similar work please visit the “Contact Us” page at


Disney Springs – GPRS Project in Orlando, FL

Above is a picture of Nate Schmoe, of GPRS, Inc. scanning the slab on grade surface.


Ground Radar Scanning
Forms YouTube LinkedIn Blog Twitter Facebook Contact Us Privacy Policy Disclaimer Forms Past GPR Projects About Us